The two gear shafts of the DA350-61 centrifugal compressor are placed in parallel on the horizontally split lower casing, and each gear shaft is supported by two bearings. The large gear shaft is a drive shaft, and the support bearings at both ends are round and horizontal bearing of the upper and lower halves, and the pinion shaft is a driven shaft, which forms a high speed rotor with the impeller. The rotor is supported by the tilting pad bearing, and the bearing hole diameter is ψ95 0.030. During operation, the main shaft is driven by the gear to drive the gear shafts on both sides to rotate, and the gas compression process is completed by the impeller and the diffuser. Maintaining a reasonable clearance between the shaft and the bearing bush is a prerequisite for the formation of a stable oil wedge by the formation of a liquid friction between the shaft and the bearing bush, accumulating and cooling the lubricating oil. Accurate measurement of these gaps is very important for the rotor to operate optimally.
The parallelism between the main shaft and the rotor shaft (horizontal direction) is achieved by measuring the center distance between them. By adjusting the parallelism, the gear contact surface is larger, the load distribution is more uniform, the gear tooth fatigue is reduced, and the life is increased. Before use, the measurement of the gaps in each part of the bearing is carried out by a lead-pressing method, a dial gauge, a feeler gauge or the like. Due to the different methods of each maintenance personnel, the measured data is often inconsistent. It takes a lot of time to repeat the verification for the results of the measurement. After the sample shaft is used, when measuring the tilting pad gap, just place the rotor sample shaft in the tiltable tile hole, tighten the bearing tile cover (according to the reloading requirements), and rotate the sample shaft by hand. Small, should be re-selected tile. If the sample shaft can be gently rotated and the radial gap between the sample shaft and the tilting tile is measured to maintain between 0.01 and 0.03 mm, it is the optimum gap value. Conversely, the tile can be re-adjusted.
How to use the fully intelligent electric Pressure Cooker
Electric pressure cooker is the main product produced by SUPOR. Kingdao has launched high-quality electric pressure cooker products since its inception. After five pressure cooker technological innovations, kingdao seems to have become a wind vane in the pressure cooker industry. Kingdao electric pressure cooker has many advantages. Let's take a look at the specific advantages of Supor.
1. The unique intelligent pressure sensing system in kingdao electric pressure cooker can realize the whole process intelligent sensing as soon as the ingredients enter the pot, so that the food can be cooked under the best pressure and release the deepest delicacy.
2. During cooking, kingdao can sense the temperature in the pressure cooker in the whole process and adjust the pressure in time to ensure that the food can have appropriate pressure in different cooking processes, so that the nutrition of the food can be fully released and the most nutrition can be retained at the same time.
3. Intelligent switching between different pressures and dynamic pressure relief technology make the food more delicious.
4. The pressure window opened on the electric pressure cooker allows the pressure at every moment in the cooking process to be clearly presented, and the pressure is presented in real time, making it safer to use. 5. The 360 degree safety protection system has once again set off the latest standard of safe cooking.
Multifunction Pressure Cooker,Nail Salon Heater,Nail Heater Dryer
Shenzhen Ewong Technology CO.LTD , https://www.ewong-tech.com